Coban GPS306 OBD


Connection Parameters

Server Address
Server IP
Server Port 47750
Desteklenen Fonksiyonlar
Otomatik Aktivasyon
Sunucu Uptime

Bu cihaz sistemimiz ile uyumludur, Eğer bu model bir cihaza sahipseniz cihazınızı online otomatik aktivasyon ile sistemimize transfer ederek, GP-S.Net ‘in ekonomik tarifeleri ile tasarruf eder ayrıca tüm özelliklerinden ve mobil uygulamalarından faydalanabilirsiniz.


Coban GPS306 is an OBDII tracker. It can be is easily installed into the car diagnostic port.

GPS306 model is embedded with GPS and doesn?t have support of GLONASS and alternative systems. It either doesn?t support Assisted GPS (A-GPS) technology. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).

There are only two basic tracking modes, which do not provide too much flexibility: by time interval and by distance.

Also, the tracker supports turnings. It will update the positions automatically to web server once the vehicle changing driving direction over pre set angle (30 degrees) to form a smooth trajectory consistent with the actual road, this function is only effective in GPRS mode.

GPS306 can read from OBDII port such data as vehicle speed, engine RPM, coolant temperature, board voltage as well as ?Check engine? (MIL) and DTC error codes. Here is an example of how it looks in GPS tracking system:


With Quad-band GSM 2G module GPS306 can be operated all over the world.

GPS306 has a small SOS button. To send the SOS signal it?s required to hold the button pressed within 3 seconds.

GPS306 uses OBDII Connector Type B and voltage range 9-40V, which makes possible to install GPS306 both on cars and trucks.

GPS306 also features a built-in rechargeable backup battery. When fully charged it ensures about 1-2 hours of device operation (in normal conditions).

When being unplugged from the OBDII socket the device sends notification to server.

GPS306 tracker can be fully controlled over GPRS, including configuration of tracking modes and controlling outputs. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back. It supports remote APN settings configuration by SMS.

You can also configure GPS306 from a PC, but you will require a special serial cable, which is not included into a standard package. No special software is required: device is detected as a flash drive and all configuration can be done by editing a text file on it.

GPS306 has two LEDs

Green LED indicates GSM/GPRS mode
Blue LED indicates GPS reception
GPS306 features a micro SD slot, so you can install a micro SD card into it and store all data there. Later you can analyze it, using proprietary software.

Also GPS306 features a built-in microphone for acoustic surveillance.

GPS306 does not detect harsh driving behaviour and towing.

General information
Purpose Vehicle
Installation Not required
Special form factor OBDII Dongle
Size 64.5x50x27 mm (2.54×1.97×1.06 in)
Weight 60 g (2.12 oz.)
GNSS Location
Internal antenna (GNSS)
External antenna (GNSS)
Assisted GPS
Cellular network type GSM Quad Band
Cellular network generation 2G
Internal antenna (Connection)
External antenna (Connection)
ACC/Ignition input Feature already supported
Hardware features
Built-in battery
Battery capacity 200 mAh
Emergency button Feature already supported
Detach sensor
Non-volatile memory Optional
Hardware extras
Voice listening Feature can be supported upon request
Emergency button Feature already supported
Tracking features
Tracking modes Continuous
Smart power consumption
ECO driving
Location by Cell ID Feature already supported
Events monitoring
Battery low Feature already supported
Device switched on/off
Self monitoring
Network signal level
GNSS signal level
GNSS satellites fixed
External power source voltage Feature already supported
CAN/OBDII reading
CAN/OBDII reader type Feature already supported
CAN/OBDII parameters Fuel level, fuel consumption, engine RPM, throttle position, speed, coolant temperature and other
DTC codes reading Feature already supported
Check engine light Feature already supported
Remote management
Server connection setup over SMS Feature already supported
Device ID type Static (IMEI)
Remote device configuration Yes (over GPRS)
Forced GNSS location update over SMS Feature can be supported upon request
Forced LBS location update over GPRS
Message exchange format ASCII
Firmware update OTA

Bu cihazı başka bir yerden satın aldım sisteminizi kullanabilirmiyim?

Evet, cihazınızı kolaylıkla sistemimize aktarabilir ve mobil uygulamalarımız dahil tüm özelliklerinden faydalanabilirsiniz.

Cihazımı nasıl GP-S.Net ' e transfer edebilirim?

Bu konuda endişelenmeyin GP-S.Net’ in benzersiz otomatik aktivasyon özelliği sayesinde herşey online ve otomatik olarak gerçekleşir.

Aktivasyon yada transfer işlemi ne kadar sürer?

Sadece bir kaç dakika sürmektedir, cihazınızı sökmeniz yada bilgisayara bağlamanız vb. işlemler gerektirmez, otomatik aktivasyon çok kolaydır, herhangi bir teknik bilgi gerektirmez ama olurda yardıma ihtiyaç duyarsanız bizimle irtibata geçin tüm işlemleri sizin adınıza yapabiliriz.

Sepetiniz şu anda boş.

Mağazaya geri dön